Garage Door Opener Repair in Attleboro, MA
An opener that hums without moving, reverses before the floor or ignores the remote usually has a specific, fixable cause. We repair garage door openers for Attleboro homes and check that the door itself is healthy before blaming the motor.
Common garage door opener problems
These are the complaints we hear most about openers.
- The motor runs but the door doesn't move.
- The door starts closing, then reverses back up.
- The remote or keypad stops working but the wall button still does.
- The opener clicks or hums and nothing happens.
- The door only closes if you hold the wall button down.
Is it the opener or the door?
Door problems
A broken spring, snapped cable or door off its track will stop even a perfect opener. The opener is designed to guide a balanced door, not to lift its full weight.
Opener problems
Misaligned photo-eye sensors, worn drive gears, a slipping belt or chain, travel limits out of adjustment, or a logic board or remote that has lost its programming.
Why the door reverses before it closes
The most common cause is the safety sensors near the floor. If one has been bumped or the lenses are dirty, the opener sees an obstruction and reverses. That is the system doing its job.
Close-force and travel limits can also drift, especially after a door has been repaired or the slab has moved in a freeze and thaw cycle.
Cold weather and openers
Grease in the drive thickens in the cold, which makes an older opener work harder. Some doors feel stiff on a freezing morning for the same reason.
A frozen bottom seal can hold the door to the slab. Running the opener against it strains the gear, so free the seal first.
Check the door before forcing the opener
If the door is crooked, very heavy, or a spring is broken, don't keep pressing the button. Pull the emergency release only when the door is fully closed or you're sure the springs are intact.
How opener repair works with us
Test the door
Disconnect the opener and check the door moves freely and holds at mid-height.
Check safety
Clean and align the photo-eye sensors and test the auto-reverse.
Diagnose
Inspect gears, belt or chain, limits, wiring and the logic board.
Repair
Replace worn parts, reset limits and force, and re-pair remotes.
Repair the opener, or replace it?
Most openers are worth repairing. Replacement makes sense when the unit has no photo-eye safety sensors, parts are no longer available, or you want quieter belt drive or smartphone control.
Our other garage door services
- Garage Door Spring Repair
- Garage Door Cable Repair
- Garage Door Roller Repair
- Garage Door Installation
- Garage Door Opener Installation